How to install our ful auto capsule filling machine

- Dec 17, 2019-

The machine shall be installed on level ground of adequate bearing capacity. Should the machine be installed upstairs, the bearing ability of the floor shall not be lower than 800 kg/m2. Rubber cushion shall be installed to resist shock. The bench of the machine shall be adjusted to horizontal level with level instrument.

Further check: manually rotate the machine for some rotations and lubricate every part in accordance with relevant stipulation.

To prevent contamination, carefully clean all parts that directly contact the medicine with alcohol.

Do not turn on the power switch unless you make sure the voltage and frequency are suitable for this machine. Since frequency converter controls motor of machine, the Revolving Platform is always rotating clockwise. Check whether the rotational direction of dust collector is identical to the mark, if the direction is wrong, exchange the two wires of power supply. The vacuum pump, dust collector and mix motor are identical in the inner line.

5.1 Replace filling tools

To change the size of capsule, replace corresponding upper and lower die assemblies, capsule feeding plate, horizontal fork, vertical fork, strai9htener, filling rod and dosing disk.

5.1.1 Replace filling die assembly (refer to Fig. 6)

Loosen the fastening screws of upper cover plate of revolving platform and remove the upper cover plate, loosen and remove fastening screws on the upper and lower die assemblies and take out the two die assemblies. Then install the lower die assembly of another specification; align two positioning holes with two column pins of T-type axle and tighten screws. Then install the upper die assembly; insert the regulating rod of each pair of upper and lower die assemblies in the two holes at the outside respectively at Station 8 to regulate their concentricity; then tighten the screws. Make sure the regulating rod rotates freely in the holes of upper and lower die assemblies.

Caution: Move the arbor wheel of the main motor with hand shrank in replacing the die assembly and rotate the revolving platform. Remove the regulating rod before rotating!